Keyence Visual KV Series Manual de usuario descargar pdf (Pagina 145)

Chapter 4 KV-D20 Operator Interface Panel

1-121

Visual KV

Series

4.2 Overview and Operation

Displaying contact comments

• The contact comments for the specified devices are displayed from the left end,

provided they are set with alphanumeric characters. However, only comment 1 is

displayed.

• Up to 20 characters can be displayed for a comment. The 21st and following

characters are not displayed.

• If a numeric value and a comment overlap, the numeric value has priority to be

displayed.

• If a device has no contact comment, the device number is displayed.

• If a contact comment is changed and transferred to the KV unit, disconnect the

communication cable of the KV-D20 once and connect it again. This updates the

display.

Note 1: To enter a space to the left of a contact comment, input "~" (swung dash) at

the left end of the comment with the LADDER BUILDER for KV. Spaces without "~"

at the left end will be ignored. When "~" is used in the middle of a contact comment,

it is displayed as "➞".

Note 2: Contact comments can be displayed only when the LADDER BUILDER for

KV Ver. 1.5 or later is used and the compression transfer of contact comments is not

selected.

Note 3: Even the contact comments for ladder programs created with LADDER

BUILDER for KV Ver. 1.0x or KV-IncrediWare (DOS) can be displayed on the KV-

D20 after being transferred to the KV unit with the LADDER BUILDER for KV Ver.

1.5 or later.

Note 4: "Not transfer" is initially set as the contact comment transfer setting of the

LADDER BUILDER for KV Ver. 1.5 or later. To display contact comments on the KV-

D20, enable the contact comment transfer setting with the LADDER BUILDER for

KV Ver. 1.5 or later.

➮

Refer to "Chapter 1 Software-Windows [KV-H6WE2]" on page 2-1.

KVHKA Chap 04.p65 08.3.11, 11:13 AM121

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 443 444

Sin comentarios

Keyence Visual KV Series Manual de usuario Pagina 145