Keyence EX-V Series Manual de usuario descargar pdf (Pagina 52)

Chapter 3 Use of Common Functions

3.2.6 Output form selection function [I]

This function is used to select the output form from the open-collector (HIGH, GO,

LOW) to output the signal for indicating that the measured value is out of the

tolerance range.

*"3" is displayed only when normal measurement in the manual mode or continuous measurement in

the thickness/gap mode is selected.

Setting function "I"

1. Press the key for at least 2 seconds.

The sensor enters the common function selection mode.

2. Press the

key to make "I" flash.

3. Press the

or key to enter the output form selection state.

4. Press the

key to select the desired function number.

Pressing the

key changes the function number sequentially.

5. Press the

key.

The sensor saves the setting and returns to the measurement state.

noitcnuF

.oN

emaNnoitarepO

lamron.O.N

tuptuo

)tcatnoc-a(nepoyllamronasasevrestuptuorotarapmocehT

.langis

lamron.C.N

tuptuo

)tcatnoc-b(desolcyllamronasasevrestuptuorotarapmocehT

.langis

dloh.O.N

tuptuo

litnuseunitnoctuptuoehtdna,deniatersituptuolamron.O.N

.deniatertonsituptuoOG,revewoH.tupnisilangistesereht

yaled-ffo.O.N

tuptuo

.sm06ybdeyaledsituptuolamron.O.N

SET

CALL

HIGH TIM

LOW

FUNC

UTILITY

MODE

CALIB

N.O. normal output

N.C. normal output

N.O. hold output

N.O. off-delay output

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 119 120

Comentarios a estos manuales

Lao 20 Nov 2024 | 23:59:11

Keyence EX-V Series Manual de usuario Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Keyence EX-V Series