Keyence EX-V Series Manual de usuario descargar pdf (Pagina 48)

Chapter 3 Use of Common Functions

Selecting the output method

1. Press the key for at least 2 seconds.

The sensor enters the common function selection mode.

2. Press the

key to make "F" flash.

3. Press the

or key to enter the monitor output setting mode.

4. Press the

key to display "F-1".

Press the

key to enter the monitor output method selection state.

5. Select the desired output method.

Pressing the

key changes the function number.

Reference: When using the hold mode in the bottom-dead-center or eccentricity/

vibration mode (in which only the operation result is retained and displayed), set

the output method to "F-11". This allows you to check the current change of the

measured value.

6. Press the

key to save the output method setting.

After saving the setting, the sensor returns to the measurement state.

Outputs the input value.

Outputs the displayed value.

noitcnuF

.oN

noitcnuF

01-f

golanastuptuorosnesehT

ehtotgnidroccaegatlov

.eulavdeyalpsid

11-f

ehtgniretlifrognilacsretfA

ehtmorftupnilangis

rosneseht,daehrosnes

.langisehtstuptuo

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 119 120

Lao 20 Nov 2024 | 23:59:11

Keyence EX-V Series Manual de usuario Pagina 48