Keyence FS-N10 Series Manual de usuario descargar pdf (Pagina 56)

4-3 Detection Settings (Func)

Settings for Advanced Functions

4-10

- Digital Fiber Sensor FS-N10 Series User's Manual -

• When the received light intensity stays lower than a given warning

level, the received light intensity correction stops and the DTM

indicator flashes.

"Changing the warning output level" (page 4-13)

• The light intensity correction stops if the raw received light inten-

sity drops below 50 (200 when the light intensity expansion setting

is set to FuLL). The raw received light intensity can be confirmed by

pressing the [MODE] button for longer than 3 seconds on the Basic

screen.

"Display Gain" (page 4-32)

• By pressing the [PRESET] button,

the current value (received light

intensity) can be forcibly calibrated

to "100.0". Calibration is completed

when the current value stops flash-

ing. (At this time, the setting value is internally calibrated so that the

received light intensity and setting value ratio stay constant.)

•You can also set the interval for executing correction, and/or the level of

received light intensity change for issuing a warning.

"Adjusting the correction interval" (page 4-12)

"Changing the warning output level" (page 4-13)

•The saturation level is fixed to 101P (101%). To display a value higher

than 100.0, turn the preset saturation function OFF.

"Preset Saturation Function" (page 4-28)

Point

Reference

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 115 116

Sin comentarios

Keyence FS-N10 Series Manual de usuario Pagina 56