Keyence GT2-100 Series Manual de usuario descargar pdf (Pagina 3)

GT2-100-M-E

●

Mounting on a table

When mounting the amplifier on a table, use the large amplifier

mounting bracket (OP-84331).

Create on a table opening for mounting referring to the

dimensions below.

Attach the large amplifier mounting bracket (OP-84331) on the

amplifier.

Use the four tapping screws supplied with the large amplifier to attach the

mounting bracket.

Secure the amplifier with M4 screws.

■

Connecting the power supply

●

Applicable wire

For the wire for the power supply, use the wire that meets the

following specifications for the power supply wire.

Wire size : AWG26 to16

Cross-sectional area : 0.2 to 1.65 mm

●

Crimp-type terminal

The power supply terminal of the amplifier uses M3 screws.

Use the Y or round terminal in the following size

Y terminal

Applicable dimension

B: Outer size of Y area 6 mm max.

d: Width of inner Y area 3.2 mm min.

(joint area with screw)

Round terminal

Applicable dimension

B: Outer size of round area 6 mm max.

Diameter of inner round area

3.2 mm min.

(joint area with screw)

■

Connecting the I/O connector

For the input and output of the GT2-100N/100P, use OP-22185 (MIL socket

connector 20-pin) sold separately.

For the information on how to assemble the connector and how to connect

the power cable, refer to "GT2-100 Series User's Manual".

●

Pin arrangement of I/O connector

Refer to page 15 of this manual for details about I/O circuits.

Connecting Three or More Heads

• Two heads can be connected to the amplifier unit (GT2-100N/100P)

as standard.

• When adding three or more heads, use the optional head expansion

board (GT2-E3N/E3P) sold separately to the rear of the amplifier.

• Three heads can be added to one head expansion board. Up to

three head expansion boards can be added. So the maximum of

eleven heads can be added.

■

Mounting the head expansion board

Detach the head expansion board connection slot cover at the

rear of the amplifier.

The cover is fixed with the M3 screws (2 pieces).

Insert the head expansion board along the guide rail.

NOTICE

Apply tightening torque between 0.8 and 1.0 N•m.

150

163 min.

4-M4 tap

(unit: mm)

Secure with the included four screws.

DC20-30V

NOTICE

Make sure the head expansion board is fully seated.

φd

(When connecting the I/O connector)

(When disconnecting the I/O connector)

191715131197531

2018161412108642

ID:1 ID:0

No.

Signal name

No.

Signal name

1 HIGH output 11 HIGH output

2 LOW output 12 LOW output

3 GO output 13 GO output

4 HH output 14 HH output

5 LL output 15 LL output

6 PRESET input 16 PRESET input

7 BANK A input 17 BANK A input

8 BANK B input 18 BANK B input

9 RESET input 19 RESET input

10 TIMING input 20 TIMING input

Head expansion board connection slot

1 to 3

1 2 3 4 5 6 7 8 ... 15 16

Comentarios a estos manuales

Sin comentarios

Keyence GT2-100 Series Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Keyence GT2-100 Series