Keyence CV-X Series Manual de usuario descargar pdf (Pagina 5)

KEYENCE CORPORATION. Vision System Division

‐ 5 ‐ www.keyence.com

Select [PLC] > [Transfer] >[To PLC].

Open [IO Table and Unit Setup] on the left side of the screen, and register the Ethernet link unit in an empty slot.

Double-click the registered Ethernet link unit (CJ1W-ETN21 in this example) to edit the parameters.

Configure the following settings in [Edit Parameters].

1. For [FINS/UDP Port], select "9600", the default value (the default value is also 9600 for CV-X).

2. Set [IP Address/Subnet Mask]. Enter the "IP Address" set in CV-X Global Settings.

3. Enter the CV-X NODE No. and IP Address into [IP Address Table] (the default CV-X NODE No. of 001 is recommended).

4. Set [Port No.] to 0.

After completing the settings, press "OK".

1 2 3 4 5 6 7 8 9 10 ... 21 22

Sin comentarios

Keyence CV-X Series Manual de usuario Pagina 5