Keyence CV-X Series Manual de usuario descargar pdf (Pagina 14)

KEYENCE CORPORATION. Vision System Division

‐ 14 ‐ www.keyence.com

4. Controlling the Controller (PLC-Link) [SYSMAC CJ Series]

✎ Checking the Global Settings of the CV-X Series

On the "Global" menu, select [Communications & I/O] > [PLC-Link] to open the global "PLC-Link" settings

screen.

Check the setting items necessary for controller control.

Select the Command Execute Event.

Select Polling for Command Execute Event.

Select "OK" to close the global "PLC-Link" settings screen.

Check the data memory to use for the following three items.

‐ Command Address

‐ Command Complete Address (bit)

‐ Command Result Address

The data memory address to use can be changed.

Be careful not to specify an address of a data memory being used for another program of PLC.

* The screen on the left shows that

Mode is set to "PLC‐ Link (Ethernet)",

but the settings (in the red frame) in

this section (Controlling the

Controller) are the same as those of

"PLC‐ Link (RS‐232C)".

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Keyence CV-X Series Manual de usuario Pagina 14