Keyence PX-10 Manual de usuario descargar pdf (Pagina 9)

Connecting the Cables and the IDC Connector

Note

When the cable length of the sensor head is changed, be sure to connect the ampliﬁer

to check that it operates correctly.

1 Manipulate the end of the cables as shown in the following ﬁgure.

•

Peel back the insulation 10 mm from the end. (Do not strip the wires in the core.)

•

Twist the base of the shielded wire at least ﬁve times so it does not unravel,

and bend it 90° to the side.

* Be careful not to twist the core wires along with the shielded wire.

If the wires become twisted, untwist them slightly and pull the core wires apart

from the shielded wires.

2 Align the core wires with the same color as indicated by the sticker on the IDC

connector and insert the wires as shown below.

• Insert the two wires (one black and one white) for the black cable (receiver

side) into the connector completely.

• The red wire for the gray cable (transmitter side) cannot be inserted

completely, but insert it as far as it can go.

• Twist the shielded wires in the direction of the arrow while pulling them into

the ditches.

3 Close the IDC connector, crimp it tight with pliers or a similar tool, and push

down on the top to lock it shut.

Note

Be careful not to crush the raised portion shown in the diagram when using pliers.

4 Use wire cutters or a similar tool to trim off the wires sticking out of the IDC

connector.

Note

Do not install the connectors more than two times. If the installation exceeds twice,

purchase OP-77758 (two connectors) separately.

If "ErH" appears on the ampliﬁer even when using pliers to crimp the connector,

press the cable (part A) between the metallic contacts with a thin tool such as a

flathead screwdriver to crimp the cable more firmly.

Mounting the Connector

1 Install the IDC connector tight with Cap B.

2 Slide the packing and the mounting ﬁxture in the direction of the arrow to

combine them.

Insert the packing into the hole in Cap B and combine the parts so that the

raised portion on Cap B lines up with the notch on the mounting ﬁxture.

3 Push Cap A in the direction of the arrow and turn it clockwise to lock it into

place. Tighten Cap A while pushing on the IDC connector as shown in the

diagram below.

90°

Core wires

90°

Shielded wire

Red

White

Black

Shielded wire

Raised portion

Back Front

Part A

Metallic

contact

Cable

Metallic

contact

IDC connector

Cap B

Mounting ﬁxture

Cap B

Packing

Raised

portion

Cutout

Tighten the parts until there

is no gap between them.

Cap A

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Keyence PX-10 Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Keyence PX-10